FAAC Gate Motor & Opener Nationwide

FAAC Gate Motor & Opener in Inglewood: What to Know First

FAAC gate motor and opener service in Inglewood typically runs $285 to $1,600 depending on whether we’re repairing a control board, replacing a capacitor, or installing a full operator. Most FAAC repairs in Inglewood are completed in a single visit because our trucks carry the common failure parts for the 400, 412, and 770 series on board. You’ll get a written price before we turn a single bolt, and every job leaves with our 90-Day Done Right Promise behind it.

Call (747) 340-9707

If you own a FAAC swing or slide gate operator and it’s groaning, stalling, or dead quiet, this page tells you what’s actually wrong and what it takes to fix it right. Call (747) 340-9707 and a live person answers, day or night.

How FAAC Products Fail - and How We Fix Them

FAAC builds a solid operator, but after 42 years of working on them across Inglewood driveways, we know exactly where they wear. Here’s what we see most:

• FAAC 412 and 770 series capacitor failure. The operator hums but won’t move the gate. Homeowners often assume the motor is shot and brace for a full replacement. In most cases it’s a failed start capacitor, a $40 to $90 part. We test the capacitor under load before recommending anything, because plenty of outfits will sell you a whole new operator for a part that costs less than dinner for two.
• FAAC 400 series limit switch drift. The gate stops short or slams past the closed position. FAAC’s mechanical limit switches on the 400 series can drift over years of thermal cycling, especially on west-facing Inglewood properties where the afternoon sun bakes the operator housing. We re-set the limits, verify the torque settings, and the gate closes like it did when it was new.
• Control board failure after power surges. Inglewood’s older neighborhoods have aging transformers and occasional brownouts. FAAC control boards, particularly on the E024U and 455D, don’t forgive voltage spikes. We install surge protection on every FAAC board we replace, which the manufacturer’s own installation guide doesn’t emphasize. That’s a detail you won’t find on FAAC’s website.
• Hydraulic pump seal leaks on older FAAC 400 hydraulic operators. If you see oil weeping from the operator base, the pump seals have hardened. This is a wear item, not a defect. We rebuild the pump with OEM seals rather than condemning the operator, which saves Inglewood homeowners $1,200 or more versus full replacement.
• Gearbox wear on FAAC 770 slide operators. A grinding sound during travel almost always points to gearbox wear on high-cycle 770 units. If caught early, we replace the gear set. If ignored, the motor shaft takes the damage and you’re into full operator territory. We check gearbox play on every FAAC tune-up, which is why our $89 seasonal service catches this before it becomes a $1,400 problem.

Our FAAC Gate Motor & Opener Process

Here’s how a FAAC service call goes from the time you phone us to the time the gate works again:

1. 1
   You call (747) 340-9707. A live person answers, asks what the gate is doing, and schedules a visit. No phone trees, no callbacks at 3pm.
2. 2
   We diagnose on-site. Our technician tests the operator, control board, limit switches, and power supply. Victor Salinas has been fixing FAAC units in Inglewood since they first started showing up on local driveways, so the diagnosis is usually made in the first 20 minutes.
3. 3
   You get a written price. Before any work begins, we hand you a number. That’s the price. If we open the operator and find something unexpected, we stop and call you first. No surprise invoices.
4. 4
   We repair with the right parts. We use FAAC OEM parts when they’re available locally and aftermarket parts only when they match or exceed OEM spec. For hydraulic 400 series units, we rebuild with OEM seals every time because aftermarket seals fail early in Inglewood’s heat.
5. 5
   We test the full cycle. We run the gate through 10 complete open-close cycles, check the safety edges, verify the force settings, and confirm the operator stops exactly where it should.
6. 6
   You get the 90-Day Done Right Promise in writing. If anything we touched isn’t right, we come back and make it right. No paperwork, no arguing.

What FAAC Gate Motor & Opener Costs in Inglewood

Here are the ranges we quote most often for FAAC work in Inglewood:

• Capacitor replacement: $165 to $285 installed
• Limit switch adjustment or replacement: $145 to $260
• Control board replacement (E024U, 455D): $525 to $980 with surge protection included
• Hydraulic pump seal rebuild (400 series): $450 to $700
• Full operator replacement (swing or slide): $1,150 to $1,600 installed, including removal of the old unit
• Battery backup installation: $385 to $650

What moves the price: the specific FAAC series, whether the operator is swing or slide, and whether we’re repairing an existing installation or correcting someone else’s botched work. Estimates are free. You’ll know the number before we start, and it won’t change when the job is done.

Why Inglewood Homeowners Call Ironworks Gate Co. for FAAC Work

We’ve been working on gates in Inglewood since 1984, and a great many of those gates were FAAC operators. When your gate quits, you don’t want a generalist who’s going to Google the error code on your driveway. You want a technician who’s already seen that failure on a dozen other FAAC units and knows the fix without guessing.

Victor Salinas grew up in the Morningside Park neighborhood of Inglewood, where his grandfather kept a small welding shop and taught him early that metal work is patient work. He has run Ironworks Gate Co. out of this same city ever since, and he’s known locally as the guy you call when another outfit has already made a mess of your operator motor and you need it done right the second time.

We service FAAC and eight other automation brands, including LiftMaster, Mighty Mule, Ghost Controls, and DoorKing, so if it turns out your FAAC operator isn’t worth saving, we can quote you a replacement from a brand that fits your gate and your budget. Every job leaves with the 90-Day Done Right Promise, and every call is answered by a live person. We do it right once, so you do not have to call twice.

FAQs