FAAC Keypad & Intercom Repair Nationwide

FAAC Keypad & Intercom Repair: The Inglewood Owner’s Guide

FAAC keypad and intercom repair in Inglewood typically runs $185 to $420 installed, depending on whether we can salvage the existing housing or need a full unit replacement. We stock FAAC-compatible keypads, intercom modules, and wiring harnesses on our trucks, so most calls are handled same-day. The usual story is a keypad that worked fine for a decade suddenly going dead after rain, or an intercom that buzzes but won’t release the gate anymore. If you live west of Prairie or up near Lock haven Park, you know how hard our marine layer and dry-season dust work on exposed electronics. We have been fixing these exact failures across Inglewood for over 42 years, and we can usually tell you what is wrong before we even roll the truck.

Call (747) 340-9707

Which FAAC Models This Applies To

We service the full FAAC residential line still common in Inglewood driveways: the older 460 and 750 series gates, the 391 and 422 operator lines, plus the newer S418, C721, and C850 slide operators that many estates near Ladera Heights run. The keypad side breaks down into two families: the FAAC 2000 series keypads (brass-faced, hardwired, and still on a surprising number of gates we see) and the FAAC XKP series, which replaced them and uses a different wiring pin order. That is the compatibility gotcha worth knowing: a FAAC 2000 keypad will not drop onto an XKP wiring harness without a relay adapter, and wiring it anyway is how we end up replacing a second keypad after someone’s first attempt fried the board.

On the intercom side, the FAAC HandyKey and the FAAC Mito intercom are the two we see on older Inglewood estates, while anything installed in roughly the last eight years is usually running a FAAC wireless keypad paired to a receiver board inside the operator. The fastest way to know what you have is to snap a clear photo of the label inside the keypad housing or on the back of the intercom station before you call. We will tell you over the phone whether it is an OEM-only swap or whether a quality aftermarket equivalent will serve you better. For FAAC specifically, we lean OEM on the keypad boards and relays because the aftermarket versions sometimes skip the weather-sealing gland on the wire entry, and in Inglewood, that seal is not optional.

Signs Your FAAC Keypad or Intercom Is Failing

• The keypad accepts some codes but not others. This is usually a worn membrane or a failing tactile switch on one or two buttons. The fix can be as small as a membrane replacement, which we keep in the truck for the most common FAAC models.
• The gate opens from the house button but not from the keypad. That points to the keypad itself or its wiring run, not the operator. We test the keypad’s relay output right at the post before we touch anything on the motor.
• The intercom crackles or the voice cuts out mid-sentence. In Inglewood’s dry months, dust gets into the speaker cone; in the wet months, corrosion does the same to the board traces. Both are repairable, but the corrosion version needs to be caught before it reaches the amplifier chip.
• The gate opens randomly, or the intercom hums when no one is there. This is a moisture or ground fault on the wire run, common after heavy rain near Centinela Park where lots slope toward the street. We trace the run and seal the fault point rather than masking it with a band-aid repair.
• The keypad is sun-bleached and the numbers are gone. FAAC keypad faces are UV-stable, but nothing survives 15 years of Inglewood sun without fading. If you are pressing letters by memory and your guests are not, the unit has lived a full life.

Replacement Cost & What’s Included

In Inglewood, most FAAC keypad replacements land between $185 and $320 installed, which includes the keypad or intercom unit, the wiring check, the relay or receiver if needed, and reprogramming all codes on site. Intercom-only jobs run $150 to $260, and a combined keypad-plus-intercom swap on an older estate gate can run toward $420 when we have to re-run the wire between the post and the house. We quote the full price before any work starts and we honor that number. If we find a corroded wire or a bad receiver mid-job, we stop, show you what we found, and give you a revised number before we turn another screw. The work itself is covered by our 90-Day Done Right Promise, and we hand you a written guarantee before we leave the driveway.

DIY or Call Us?

On a FAAC keypad or intercom, there is one safe check you can do yourself: clear away any dirt or spiderwebs around the keypad face, and confirm the wire at the bottom of the post has not been chewed by a dog or nicked by a weed whacker. That is where we stop the do-it-yourself conversation. These units are low-voltage, so you are not looking at a shock hazard, but what makes them dangerous to DIY is the wiring. FAAC keypads and intercoms carry a small data signal along the power line, and crossing a wire on the wrong terminal sends voltage straight back into the operator’s control board. A $65 DIY keypad becomes a $600 board replacement faster than most homeowners expect, and we have replaced enough operator boards in this city to know it happens every year. If you are seeing any of the symptoms above, call us at (747) 340-9707 and we will check it properly.

FAQs